國產產品特點

1．能快速聚集各種熔渣和雜質，渣膜聚集不破，可一次性整體挑出除渣徹底。

2．不粘包，不損壞包壁、爐壁，有效延長爐襯包襯壽命。

3．幸免鑄件夾渣，提高鑄件質量降低鑄件廢品率。

4．在鑄液中膨脹系數大，快速結膜，比重輕，有效保溫。

5．拋灑時無粉塵，不飛濺、不危害車間環境和人體健康。

6．高性價比、穩定的質量，利于企業節約成本。

使用方法

1．除渣劑可在澆包、坩堝爐、電爐、澆鑄機中使用。用人工或噴槍撒布于溶液外表盡也許拋灑均勻以減少用量。

2．稍加攪動后，除渣劑在快速均勻膨脹的同時，在溶液外表急速結膜、與礦渣粘合在一起，集聚成與金屬溶液容易分離的渣膜。

3. 用適當工具挑出渣體，便可獲得干凈的金屬溶液。

4．除渣劑撒少許籠罩外表即可澆注，用量依據溶液的種類、溶液的含渣量、溶解爐的容量和對鑄件質量要求而定，一般情況下使用量為溶液的0．1％一0．3％。

國產產品包裝

  25kg編織袋或1 000kg噸袋

Characteristics：

1．Can quickly gather a variety of slag and impurities，slag film aggregation does not break，can be a one—time whole to pick out，slag thoroughly．

2．Non—stick package，no damage to wall，furnace wall，prolong lining life effectively．

3．Avoiding casting slag，improving casting quality and reducing scrap rate of castings．

4．In casting liquid expansion coefficient is largel rapid conjunctival|light weight|effective insulation．

5．No dust，no splash，no harm to workshop environment and human health．

6．Cost—effective，stable quality，conducive to cost—saving enterprises．

Method of use：

1．Slag removal agent can be used in pouring ladle，crucible furnace，electric stove，casting machine．Sprinkle with artificial or spray gun on solution surface as much as possible to reduce dosage．

2．After a little stirring，slag removal agent in the rapid unifOrm expansion at the same time，rapid conjunctival on the surface of the solutionl and slag bonded togetherl gathered into a metal solution easily separated from the slag film．

3．A clean metal solution can be obtained by using the appropriate tool to pick out the slag body

4．The slag can be poured on a little covering surface，the dosage is 0．1％一0．3％according to the type of solution，the slag content of solution，the capacity of the dissolved furnace and the requirement of casting quality．

package：25kg woven bag or 1 000kg bagged packing．